"Homemade Carolina Windom Antenna" (Off-Center Fed Dipole).

Views expressed in this post are those of the reporters and correspondents.

Accessed on 30 November 2025, 1432 UTC.

Content and Source provided by John (M0UKD).

https://m0ukd.com/homebrew/antennas/homemade-carolina-windom-antenna

Please check URL or scroll down to read your selections. Thanks for joining us today.

Russ Roberts (KH6JRM).

Homemade Carolina Windom antenna

Coax fed OCF ‘Windom’ antenna

Here is my home HF antenna. It is an off centre fed dipole, with 10 feet of vertical radiator. It needs no tuner on 40m, 20m and 10m. It also works fine on all bands above 40m with a tuner, and even below 40m on 60m, and 80m, although the coax losses will be higher. I have even used it on 160m, but it is very inefficient there. Ideally, this antenna should be at least 35 feet above ground, but mine is currently about 25 feet, and still performs OK. The radiation pattern is improved if it is above 35 feet.

S.W.R. Graph

Holding true to the original Windom formulas, I used a ratio of 37.8% for one side and 62.2% for the longest side after determining the half wave length at the lowest operating frequency…. This is the 200Ω point, hence the 4:1 balun. (50Ω to 200Ω)

The 10 feet vertical radiator really does radiate, and offers vertical radiation to the existing horizontal radiation, and therefore adds to the low angle omnidirectonal radiation. The line isolator stops the vertical radiator radiating all the way back to the shack.

This is the same design as the ‘Carolina Windom 80 Special’ You can buy one of these for £109.95 but this cost nothing like that!

Here is the 4:1 balun. It is 17 bifilar turns on a half inch ferrite rod. 50Ω – 200Ω, 1-30MHz. Analyzer shows 1.1 SWR @ 50Ω to a 200Ω resistor from 1 through to 30MHz